| |
|
Piping Designer
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
|
| Education: 4 |
| Experience: 10 years |
| Relocation: Yes - Internationally |
Career Objective |
To assume Piping Designer position to an EPC company.
|
|
Professional Experience |
Present Company : ADGAS
Position : Senior Piping Designer
Inclusive Date : April 01, 2005 – Present
Duties/Responsibilities
Designs, develops and prepares from original sketches, piping layouts, major equipment layouts, structural layout and site dimensions.
Previous Company : SMOE(Sembawang Marine & Offshore Engineering)
Position : Senior Piping Designer/Checker
Inclusive Date : Sept 16, 2004 – March 31, 2005
Duties/Responsibilities
• Check Piping isometrics against Master P & ID and project specifications considering the intergrity of the design and recommended practices.
• Responsible for Checking of Piping/Equipment Layout designed by KBR to be workable, in accordance with ASME/API codes & safety standards.
Perform detailed piping layout/design of process & utility lines taking into consideration its operability, maintainability, accessibility,
cost-effectiveness & other project specifications.
• Perform study/calculations of pipe spool weight/Inch-Dia and its impact to Offshore Hook-up installation considering fabrication, erection, and cost.
Previous Company : Fluor Daniel
Position : Senior Piping PDS Designer
Duties/Responsibilities
• Perform detailed piping layout/design of process & utility lines taking
into consideration its operability, maintainability, accessibility,
cost-effectiveness & other project specifications.
• Pipe support design & selection.
• Perform Piping PDS partition development(pipe/equipment modeling)
• Prepare sketch of Non-standard/special supports
• Communicate & interface with other disciplines such as Civil &
Structural, Control Systems, Electrical, & Mechanical Group during
the Detailed engineering/design development phase of the project.
Squad checking of equipment, Structural and miscellaneous steels.
• Self checking of isometric drawings against Master P & ID considering the integrity of the design base on project requirements, material specification,good design philosophy and practice.
Previous Company : Chiyoda & EEI Corporation
Position : Piping Design Engineer
|
Eductation |
| BSc Mechanical Engineering - Mapua Institute of Technology, Philippines |
Certification |
: PDS (Plant Design System) Intergraph,Piping, Isogen, Equipment, Drawing Manager,Interference, & Frameworks Module
PDMS (Plant Design Management System)
Piping, IsoDraft, Equipment, Draft, Clash Detection,
& Structures/Frameworks Modules
Microstation 95/SE/J
AutoCad Rel. 14/2000/2000i/2004
Design Review/Smart Plant Viewer
SmartPlant P&ID
Autoplant 97
GTX Raster
|
|
|
|
