To be employed in a well established firm where I can contribute my comprehensive, knowledge skills and experience on electrical works. Pertaining to repair and maintaining all Electrical jobs, and Instrument
April 19, 2009 Up to present ABS Group Consulting ASAB-GAS AGDII (Oil and Gas Plant Abu Dhabi (U.A.E) SR QC Electrical Inspector
•Installation inspection for cable termination gladding and insulation resistance test. •Monitoring of cable pulling of primary and secondary instrument and electrical cable. •Inspection of Instrument and Electrical Installation and witness the motor testing. •Inspection of all instrument electrical sub station. •Perform daily inspection of the on-going Installation at the working location with the specification and requirements. •Inspection for cable trench, sand bedding, cable laying cable tag, cable tiles, warning tape and final backfilling. •Conduct supervisory and inspection at site. •Prepared inspection report and document.
August 12, 2008 – April 16, 2009 Dodsal PTE Limited. Common Cooling Seawater System Phase - II EPIC RAS LAFFAN INDUSTRIAL CITY QATAR. SR. QC Electrical Inspector. (CCWP-II Qatar Petroleum)
•Inspection of Local Lot Control Center. •Inspection of Switchgear, Bus bar alignment and Torque •Conduct testing for Potential Transformer, Current Transformer and Insulation Resistance. •Witness testing for high and low voltage cable. •Inspection for cable trench, sand bedding, cable laying cable tag, cable tiles, warning tape and final backfilling. •Installation inspection for cable termination gladding and insulation resistance test. •Red line mark-up drawing to be prepared for changes made at site.
October 17, 2006 – July 24, 2008 Hyundai Heavy Industries Co. Ltd KOC – CEF (Admmadi) Project P.O Box. 5068 Safat. Kuwait City QA/QC E/I Engineer. (Crude Export Facilities KUWAIT OIL COMPANY)
•Inspection of Instrument and Electrical Installation and witness calibration of Instrument. •Monitoring of cable pulling of primary and secondary instrument cable. •Witness testing of insulation resistance of primary and secondary instrument cable. •coordinate with client prior to loop checking. •Performed inspection with client for acceptance of job. •Check Electrical and Instrument Installation conforming to project specification. •Inspection of Instrument and Electrical Materials. •Participate Instrument and Electrical testing such as insulation test and Hi-pot test of cable. And MOV testing. •Answer the NCR (Non Conformance Report) Issued by Consultant.
EDUCATIONAL BACK ROUND:
COLLEGE: Bachelor of Science in Electrical Engineering Graduate Technological Institute of the Philippines Manila, Philippines (1985 – 1990) Electrical Engineer Licensed
SECONDARY: High School Graduate Jose Abad Santos High School Manila, Philippines (1981 – 1985)
PRIMARY: Elementary Graduate Pedro Guevara Elementary School Manila, Philippines (1975 – 1981)
•Basic Safety Training. •Proficiency in Survival Craft and Rescue Boat. •Medical Emergency First Aid.
I would like to apply in you’re good company as a QA/QC SR. Electrical Inspector or any position available. I was been work for eight years in abroad Kingdom of Saudi Arabia for Oil and Gas and Power Plant Company and Kuwait Oil and Gas Company, and Common Cooling Sea Water Phase–II in Qatar and Gas Plant in Abu Dhabi U.A.E up to present.
I am willing to assign any location and be a part of you’re company and see attach my entire document.