I’m looking for new experience, new Challenge, learning possibility, increased responsibility and exciting opportunity where I can contribute and grow in a bigger environment.
FROM (19/2/2008) TILLNOW EGYPTIAN MAINTANANCE COMPANEY (EMC) Working as a mechanical Engineer in the following sites:
EMETHANEX Methanol Damietta 1 Project Carrying out Commissioning and Pre-commissioning activities for rotating equipments such as: • Variable types of Horizontal and Vertical pumps: Performing Orientation, Leveling, Pre-alignment and Final alignment. • Air Fan Cooler: Performing Fan shaft verticality adjustment, Tip clearance adjustment, Blade angle adjustment and adjusting the alignment between the fan and motor pulleys. • Cooling Tower: Performing Tip clearance adjustment, Blade angle adjustment, Gear box level adjustment, Motor soft foot check and alignment between the motor and the gear box using Laser alignment. • Siemens Turbo-Compressor: Performing the installation of Dry Gas Seal, Journal bearing and thrust bearing for a Siemens centrifugal compressor.
ELNG (Egyptian Liquefied Natural Gas) EDKU site. 1- May 2008 Shutdown carried out the following: • Performing LTPI Inspection for a Nuovo Pignone MS 5002 D by replacing the fuel nozzle tip, combustion chamber liner, transition piece and 1st stage nozzle. • Performing D+ Extender kit replacement for Train 1 (6 Turbines). • Performing Bucket & Cover Plate Replacement for Train 1 (6 turbines).
2- November 2008 Shutdown carried out the following: • Performing LTPI Inspection for a Nuovo Pignone MS 5002 D by replacing the fuel nozzle tip, combustion chamber liner, transition piece and 1st stage nozzle. • Performing D+ Extender kit replacement for Train 2 (6 Turbines). • Performing Bucket & Cover Plate Replacement for Train 2 (6 turbines).
3- November 2008 carried out a Major Overhaul for One gas turbine Nuovo Pignone MS5002D including the following: • Performing High pressure rotor replacement. • Performing Low pressure rotor replacement. • Performing First-stage wheel shroud replacement. • Variable 2nd stage nozzle replacement.
4- Having a good experience about Q/A&Q/C activities in the previous shutdowns as the following: • Participate in the Preparation of the required spare parts for the shutdown activities. • Dimensional checks for gas turbine spare parts. • Spare Parts Code & Serial Number recording for old and new spare parts.
GPC (General Petroleum Company) in Ra's Ghareb site. Carried out a major overhaul for a MITSUI SB30 gas turbine.
• UNIVERSITY, FACULTY B.Sc. in Mechanical Power May 2007 - Faculty of Engineering – Alexandria University. “General Grade: Very good with the honor degree”
• BACHELOR'S GRADUATION PROJECT : "Simulation & Performance of combined generation power cycle of Nubaria power plant" Subjects: Steam generator, Steam turbine, Steam Condenser, Pumps, Heat Recovery steam generator, Compressors, Combustion chambers and Gas Turbine. “Project Grade: Excellent”
• Master of Engineering at Heat Transfer field, Faculty of Engineering – Alexandria University.
• Lifting operation& lifting equipment in EMC training center (SGS). • Vibration Monitoring & Analysis in EAAC training center. • Auto cad 2D & 3D in EAAC training center in Alexandria.