To obtain a challenging position that allows me to utilize my knowledge and experience for fast growth of company.
Professional Experience
Steady state simulation and optimization in HYSYS, Dynamic simulation in UniSim, Heat and Material Balance, Process and Utility Calculation, Preparation of PFD, UFD and PSFD, Development of P&ID (process, utility and distribution),Which include indentifying instrumentation for operational control and safeguarding. Preparing and updating philosophy like Relief and Blow down, Emergency Shutdown, Process Control and Isolation. Sizing of two and three phase separator and Heat Exchanger rating in HTRI, Flare KOD Pumps and Electrical heater, Line Sizing and Pump Hydraulics and Compressor Settle Out calculation, Relief, Blow down and Flare Study includes PSV relief rate calculation, Inlet and Outlet line Sizing of PSV’s ,Flare Sizing and Blow down Calculation, Cause and Effect and ESD logic Diagram, Process datasheet preparation of Separators, Pumps, Heat Exchangers, Air Coolers and Control valves, Preparation of specification package items like Compressors, Desalter, Flare, Produced Water Treatment package, Instrument, Nitrogen Air and Fired heaters, Instrument datasheet, HAZOP participation and HAZOP Closeout related activity, and Vendor document review, Worked on Tri Ethylene Glycol (TEG) and Mol Sieve Dehydration Unit package, Preparation of Operating manual, Participated in Pre-commissioning, Commissioning, Start-up and performance guarantee run activity.
