Marine engineer (4th engineer)
This is a candidate registered on Gulfoilandgas.com. To contact this candidate you need to purchase a subscription.
Experience: 3 years
Relocation: Yes - Internationally
To gain more experience in Gas or Oil industry that is crutial for my further profesional development.
I was working in the VCM/EDC production plant. The plant was in the phase of commissioning after 3 years of non/production and I was working like a piping engineer responsible of Oxychlorination procces in the production chain with all following equipment (reactor, columns, compressors, heat exchangers, pumps, ...)
My duties were piping, support & valve field inspection regarding documentation (P&ID and isometric), internal equipement inspection, ...
Responsible for piping and equipement pressure tests procedures, review of start up procedures, P&ID, isometrics, …
Preparation of documentation for installation of DCS (architecture, instrumentation, cause&effect diagrams, ...).
I was participating in a hazard and operability safety audit (HAZOP).
During my on board experience I was responsible for maintaining and repairing engine machinery such as: H.F.O. & L.O. separators, fuel, water & bilge pumps(centrifugal, screw & piston pumps), air compressors (piston), automatic filters,...
Also responsible for organization & ordering spare parts.
Helping 1st & 2nd officer in maintanence on diesel generators (4*MAN B&W engines 3000 kW each) & main propulsion engine (MAN B&W KMC-MC98 96000 BHP)
University of Rijeka
Faculty of Maritime studies
Master degree in marine engineering
Oil Treating & Refining
Oil & Gas Companies
Transport of Hydrocarbons
Ecological & Environmental
Oil and Gas Pipeline
Oil Field Services