SOCO Provides Vietnam Operations Update

Source: www.gulfoilandgas.com 5/27/2008, Location: Asia

Block 16-1- (TGD-1X-ST1): Drilling on the Te Giac Den 1X side track well on Prospect "E" has ceased after reaching 5,096 metres measured depth (MD). Primarily due to concerns over the integrity of the well bore, but also factoring in the difficulty and anticipated time and expense of deepening the hole, the decision was made to not drill an extended Basement section.

The well has been plugged back to 4,820 metres MD prior to conducting two drill stem tests ("DSTs") in the high pressure/high temperature Oligocene interval. The first DST will be over an approximate gross interval of 210 metres in the higher pressured zone below the volcanics layer, which separates the two over-pressured sections. The second DST will be in the upper Oligocene interval above the volcanics layer over an approximate gross interval of 120 metres.

Testing is expected to be completed toward the end of June 2008.

TGT-6X: The Te Giac Trang 6X appraisal well, drilled on the H4 fault block as a down dip test to the TGT-3X exploration well, reached 3,437 metres MD, as planned. Two DSTs were planned, the first of which tested an interval between 3,064 metres and 3,094 metres in the Miocene Intra Lower Bach Ho 5.2 ("ILBH") "lower" interval and flowed approximately 6,650 barrels of oil per day through an 80/64 inch choke size.

A second DST will commence shortly over an approximate gross interval of 64 metres in the ILBH 5.2 "upper" interval. Testing is expected to be completed by the middle of June 2008.

Block 9-2: A high sea state has intermittently shut down operations of the pipe lay barge thus causing some delay on the installation of the production and water pipelines between the unmanned CNV well head platform and the Bach Ho central processing platform over which CNV production will be processed. Despite this unanticipated delay, oil production remains on target to begin by the end of July 2008.


Norway >>  8/12/2022 - Aker BP ASA, operator of production licence 941, has concluded the drilling of wildcat well 6507/3-15.

The well was drilled about 14 km nor...

Norway >>  8/9/2022 - The Petroleum Safety Authority Norway has given Equinor consent for exploration drilling in block 6507/8 in the Norwegian Sea.

Operator: E...


Guyana >>  8/5/2022 - The drilling of the Beebei-Potaro exploratory well, located in the Kanuku licence, off the coast of Guyana, has been finished, according to Tullow Oil...
Australia >>  8/4/2022 - - 21 stages were stimulated, which is the greatest number of stimulation stages in a single well in the Beetaloo to date
- Delivered 927m of st...


Romania >>  8/4/2022 - Serinus Energy plc ("Serinus") (SEN), is pleased to announce that the drilling of the Canar-1 exploration well in Romania commenced.

...

Norway >>  8/3/2022 - The Norwegian Petroleum Directorate (NPD) has granted Equinor a drilling permit for well 6507/8-11 S in production licence PL 124.

Related Categories: Artificial Lift  Cementing, Stimulation  Directional Drilling  Drilling  Drilling Engineering & Equipment Systems  Enhanced Oil Recovery  General  Logging, Perforating, Testing  Offshore Drilling  Reservoir/Completion Consultants  Workover & Well Services  Workover Rigs/Services 

Related Articles: Artificial Lift  Cementing, Stimulation  Directional Drilling  Drilling  Drilling Engineering & Equipment Systems  Enhanced Oil Recovery  General  Logging, Perforating, Testing  Offshore Drilling  Reservoir/Completion Consultants  Workover & Well Services  Workover Rigs/Services 


Gulf Oil and Gas
Copyright 2021 Universal Solutions All rights reserved. - Terms of Service - Privacy Policy.